Heures d'ouverture: Lun - Mer: 10:00 - 17:30   Jeu - Ven: 10:00 - 21:00   Sam: 09:00 - 17:00   Dim: 11:00 - 17:00

MSP Musique

Lévis (St-Nicolas)
140-9, Marie-Victorin
418 831-9010
Lévis
70 Kennedy
418 903-9410

Aller au contenu principal »

Rechercher sur le site

Vous êtes actuellement sur :

Option
d'Achat

Manufacturiers
  1. Dunlop (2)
  2. EHX Electro-Harmonix (25)
  3. Korg (2)
  4. LP Latin Percussion (1)
  5. MXR (22)
  6. Pedaltrain (1)
  7. Pigtronix (2)
  8. Radial (1)
  9. Tech21 (5)
  10. Way Huge (8)
 

Effets basse

Effets basse

Parce que ce ne sont pas que les guitaristes qui ont droits à un pédaliers bien garnis...

Total des articles de 1 à 10 sur 85 Page :
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5
  6. Suivant
Afficher par page
Afficher en: Grille  Liste  Trier par Par ordre décroissant
Dunlop adaptateur 9V dc

Prix MSP: 17,95 $Ca

3A-066WP09 with input: 100-240V~, 50-60Hz, 0.3A and output: 9V, 0.67A. 2.1mm x 5.5mm, Barrel negative center. En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

Electro-Harmonix Switchblade Passive Channel Selector

Prix MSP: 46,95 $Ca

Switch your signal between two different amplifiers, two different pedal boards or two different speaker cabinets. Flexible channel switching built into a compact die-cast case.
En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

Electro-Harmonix Screaming Bird Treble Booster

Prix MSP: 49,95 $Ca

Épuisé
Based on the classic design from the '70s, the Screaming Bird treble booster is back to help your sound take new flight. Whether it's overdriving an amp or just adding some serious bite to your sound, this Bird will scream nothing but highs and will make your guitar cut through any mix. Step on the Bird and fly away! En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

Electro-Harmonix The Mole Bass Booster

Prix MSP: 51,95 $Ca

The Mole is a bass booster that helps bassists and guitarists unearth a sound that is positively subterranean. Based on the classic design, this updated pedal adds the same rich, low-end bottom while adding a 20dB boost to your signal. Whether you step on the Mole to get deep, ground-shaking drive or dial back the knob to add some texture to your existing tone, the Mole will dig wherever you tell it to.
En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

Electro-Harmonix LPB-1 Linear Power Booster

Prix MSP: 51,95 $Ca

Switch your signal between two different amplifiers, two different pedal boards or two different speaker cabinets. Flexible channel switching built into a compact die-cast case.
En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

Electro-Harmonix Chillswitch

Prix MSP: 56,95 $Ca

The CHILLSWITCH Momentary Line Selector is a new, utilitarian Electro-Harmonix pedal. In Kill Mode, the CHILLSWITCH can be used to provide instant muting. It can also be used to create interesting stutter effects by turning the instrument’s signal abruptly on and off for hard rhythmic in/out transitions.

In Line Selector Mode, the scope of the pedal’s use is only limited by the player’s creative vision. It can, for example, be used to quickly switch in the effects loop, introducing a burst of distortion, analog delay induced feedback or ring modulation. It can also be tapped in time with what is being played to bring effects in and out of the signal path rhythmically. This is especially interesting when one of those effects is a delay with tap tempo. The many and varied uses of this pedal are an open invitation for the modern player who wishes to explore the world of unorthodox sound creation and manipulation.

En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

Electro-Harmonix Signal Pad

Prix MSP: 57,95 $Ca

The Signal Pad is a passive attenuator that allows you to instantly switch to a different preset volume. It's like your guitar's volume knob, with a fully-passive and color-free circuit. Leave your amp's volume set high for overdrive, and use the Signal Pad to lower your level for a clean sound -- then switch it off to kick in your amp's natural overdrive. You can also experiment with the Signal Pad anywhere in your effects chain -- you'll bring out new tonal combinations from your favorite old pedals. En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

Electro-Harmonix série Nano switch blade +

Prix MSP: 60,95 $Ca

— Controls —
A/B Footswitch (LED) — Press this switch to route the input signal to either OUT A (Red LED) or OUT B (Green LED).

A+B Footswitch (LED) — Press this switch to route the input signal to both OUT A and OUT B. When A+B is engaged (Red LED), the A/B Footswitch has no effect on the signal path.

— I/O —
INPUT — Connect the output of your instrument or another effects pedal to this jack.

TUNER — Connect this jack to the input of a tuner device or another effects pedal. This jack is hardwired to the INPUT jack and provides a direct output regardless of the state of the unit.

OUT A — Connect this jack to the input of an amplifier or the input of another effects pedal. Depending on the state of the A/B and A+B controls, this jack will output either the direct input signal or no signal. When the A/B LED is lit red or the A+B LED is lit up, OUT A is selected.

OUT B — Connect this jack to the input of an amplifier or the input of another effects pedal. Depending on the state of the A/B and A+B controls, this jack will output either the direct input signal or no signal. When the A/B LED is lit green or the A+B LED is lit up, OUT B is selected.

— Power -
The SWITCHBLADE+ can be powered by a 9V battery or a 9VDC battery eliminator capable of delivering at least 16mA. The optional 9V power supply from Electro-Harmonix is 9.6DC-200BI (same as used by Boss® & Ibanez®) 9.6 Volts DC 200mA. The power supply must have a barrel connector with center negative.

The SWITCHBLADE+ can also operate without power, since the audio path is fully passive. With no power, however, the LED indication will not function.

When A+B is engaged, the input impedance at the INPUT jack is equal to 50kΩ in parallel with the combined input impedances of the devices connected to the TUNER, OUT A, and OUT B jacks. When A+B is not engaged, the input impedance at the INPUT jack is equal to 100kΩ in parallel with the combined input impedances of the devices connect to the TUNER jack and OUT A or OUT B. En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

MXR M197 Loop Box Pedal

Prix MSP: 65,95 $Ca

Take signal degrading pedals our of the signal path.
Heavy duty switches, jack, and die cast housing.
Simple operation and layout.
Send jack is terminated with 10K in bypass.
All switching is true hardwire. En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

MXR M196 A/B Box Pedal

Prix MSP: 84,95 $Ca

Dunlop MXR M196 A/B Box

MXR A/B Box allows you to deliver your instrument's signal to two separated output. Use it to select different amps or to use both at the same time with different effects. Use the Thru output to connect a tuner, an amplifier, or any device which needs to receive the signal always. En savoir plus

Ajouter à ma liste d'envies | Ajouter au comparateur

Total des articles de 1 à 10 sur 85 Page :
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5
  6. Suivant
Afficher par page
Afficher en: Grille  Liste  Trier par Par ordre décroissant
 

Comparer des
Produits

Vous n'avez pas d'articles à comparer.